|
Titel:
|
|
Use of stainless steel for bipolar plates in the SPFC
|
|
|
|
Auteur(s):
|
|
|
|
|
|
Gepubliceerd door:
|
Publicatie datum:
|
|
ECN
|
1-12-1999
|
|
|
|
ECN publicatienummer:
|
Publicatie type:
|
|
ECN-RX--99-041
|
Artikel wetenschap tijdschrift
|
|
|
|
Aantal pagina's:
|
|
|
18
|
|
Gepubliceerd in: Presented at the Grove Fuel Cell Symposium, 13-16 September 1999, London, UK. - Submitted to Journal of Power Sources (), , , Vol., p.-.
Samenvatting:
Bipolar plate materials for the SPFC, alternative to the presently usedgraphite, should fulfil the following requirements in order to be applicable:
low-cost, easy to machine or to shape, lightweight and low volume,
mechanically and sufficiently chemically stable, and having a low contact
resistance. Stainless steel is a low-cost material, it is easy to shape and
thin sheets can be used yielding a low volume and weight. Several stainless
steels have been tested for their applicability. The compaction pressure is
of large influence on the contact resistance. Also the pre-treatment of the
surface is of influence; this is a permanent effect. Stainless steel
constituents slowly dissolve into the MEA. lt has been found that the anode
sided stainless steel flow plate is the main source of the contaminants. A
direct contact between the stainless steel and the membrane greatly enhances
the contaminant level. Using a proper pre-treatment and a coating or gasket
preventing direct contact between stainless steel and the membrane we found
one alloy to satisfy the requirements for use as a low cost material for the
flow plate of an SPFC. 12 refs.
Terug naar overzicht.