Publicaties

Skip Navigation Links.
Recent verschenen
Expand per documenttypeper documenttype
Collapse per Unitper Unit
Expand Business DevelopmentBusiness Development
Expand Biomass & Energy EfficiencyBiomass & Energy Efficiency
Expand BeleidsstudiesBeleidsstudies
Expand Corporate CommunicationsCorporate Communications
Expand CorporateCorporate
Expand Environment & Energy EngineeringEnvironment & Energy Engineering
Expand Program DevelopmentProgram Development
Expand Quality Safety Health and EnvironmentQuality Safety Health and Environment
Expand Strategy & PlanningStrategy & Planning
Collapse WindenergieWindenergie
2018
2017
2016
2015
2014
2013
2012
2011
2010
2009
2008
2007
2006
2005
2004
2003
2002
2001
2000
Expand Zonne-energieZonne-energie
Expand per Clusterper Cluster

Zoeken naar publicaties:
Beperk het zoeken tot de velden:

ECN publicatie:
Titel:
Transient stability of wind farms with different electrical concepts - UpWind report, Work Package 9, Task 3.1., Deliverable D9.4.1
 
Auteur(s):
Wiggelinkhuizen, E.J.
 
Gepubliceerd door: Publicatie datum:
ECN Windenergie 17-2-2011
 
ECN publicatienummer: Publicatie type:
ECN-E--11-003 ECN rapport
 
Aantal pagina's: Volledige tekst:
28 Download PDF  (1121kB)

Samenvatting:
As part of the EU 6th FP project "UpWind" Work Package 9.3 the dynamic response of two different electrical designs of offshore wind farms has been evaluated for symmetrical onshore grid faults. The first design uses an HVDC connection to shore based on voltage source converters and the second design uses an HVAC connection. In both cases the wind farm consists of variable speed turbines, with a with permanent magnet generator and full-power voltage source converter, grouped into 5 feeders connected to a single bus.
The simulation results of a 3-phase fault in the onshore grid have been compared for different minimum grid voltages, for different wind speeds and for different power ratings of the dc-link braking resistor.
In all cases the HVAC and HVDC connected wind farms did ride-through the 3-phase onshore grid fault while supporting the grid voltage during and shortly after the fault. The applied method of active power reduction of the HVDC connected wind farm by a fast decrease of the ac-voltage in the wind farm showed to be effective. Also it does not rely on communication links and also the WT converter control is very similar as in the HVAC connected wind farm. On theWT generator side the response to the applied faults was similar in the HVAC connected WF and in the HVDC connected WF as the full-rated WT converter effectivly decoupled the generator side from the WF grid side. The drive-train oscillations only depend a little on the operating conditions and are rapidly damped during the ramp up of the active power.
Due to the limitations of the models several aspects are not or not accurately represented in the results, such as harmonics, unbalance and the response of protection systems. However, the models can be used to design evaulate wind farm configurations and wind farm control systems. In order to make the models better applicable they should be validated with measurements or with other models.


Terug naar overzicht.