Skip Navigation Links.
Zoeken naar publicaties:
Beperk het zoeken tot de velden:

ECN publicatie:
Optimizing the front side metallization process using the corescan
Gepubliceerd door: Publicatie datum:
ECN Zonne-energie 1-5-2002
ECN publicatienummer: Publicatie type:
ECN-RX--02-021 Conferentiebijdrage
Aantal pagina's: Volledige tekst:
4 Download PDF  (911kB)

Gepresenteerd op: 29th IEEE Photovoltaic Specialists Conference, New Orleans, USA, 20-24 mei 2002.

In solar cel1 manufacturing it is difficult to optimize screen printedfront side metallization, in particular to obtain good contact over the entire cell. The Corescan enables mapping of contact resistance of full cell surfaces. Using these mappings, it is possible to diagnose and exclude reasons for poor contact formation. In this study, several process conditions have been studied. Cross-belt temperature non-uniformity in the firing furnace turns out to be a reason for large contact resistance differences. This shows that the acceptable firing temperature range can be considerably increased if a constant temperature profile across the belt width is realized. Further, it is shown that plasma etching for isolation gives cause for an increase of the contact resistance of the fingers at the cell edges. Finally, contact resistance differences related to emitter non-uniformity are found. To summarize, the Corescan is a powerful tool that enables easy optimization of front side metallization.

Terug naar overzicht.