Skip Navigation Links.
Zoeken naar publicaties:
Beperk het zoeken tot de velden:

ECN publicatie:
Characterization of nanoporous TiO2 films prepared by sol-gel method
Sabataityte, J.; Oja, I; Lenzmann, F.O.; Volobujeva, O.; Krunks, M.
Gepubliceerd door: Publicatie datum:
ECN Zonne-energie 1-10-2005
ECN publicatienummer: Publicatie type:
ECN-RX--05-168 Artikel wetenschap tijdschrift
Aantal pagina's:

Gepubliceerd in: Comptes Rendus Chimie (Elsevier), , , Vol., p.-.

Nanoporous TiO2 films as a key component in dye sensitized and extremely thin absorber (ETA) solar cells were prepared by the sol–gel method using spin-coating and spray pyrolysis deposition techniques. The precursor sol contained titanium (IV) isopropoxide, acetylacetone and polyethylene glycol (PEG) in ethanol. Glass and n-type Si (100) were used as substrates. SEM, XRD and FT-IR were used to study the effect of the PEG concentration in the precursor solution as well as different annealing routes on the film composition and structural properties. Crystalline films with anatase structure could be grown by the spray technique at 500 °C. Post-annealing at 500 °C increases the crystallite size (from 5 to 9 nm) and results in an average pore size around 40 nm.A film thickness of about 2.3 µm is attained using 50 spray pulses. In spin coated films the formation of Ti–O–Ti anatase bonds is observed after annealing at 450 °C. Crystalline films can be prepared by annealing at temperatures above 700 °C. Surface morphology and pore size of spin coated films are controlled by the amount of PEG in the sol. The film thickness is around 120 nm after three coating cycles.

Meer Informatie:

Terug naar overzicht.